Aeg-Electrolux HD634170NB Manual do Utilizador Página 14

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 13
WARNING!
Do not use knives, scrapers or
similar instruments to clean the
surface of the glass or between
the rims of the burners and the
frame (if applicable).
WARNING!
Do not slide cookware over the
glass because it could scratch
the surface. Also, do not let hard
or sharp objects fall onto the
glass or hit the edge of the hob.
6.1 Cleaning of the spark plug
This feature is obtained through a ce-
ramic ignition candle with a metal elec-
trode. Keep these components well
clean to prevent difficult lighting and
check that the burner crown holes are
not obstructed.
6.2 Periodic maintenance
Periodically speak your local Service
Force Centre to check the conditions of
the gas supply pipe and the pressure ad-
juster, if fitted.
7. TROUBLESHOOTING
Problem Possible cause and remedy
You cannot start the ap-
pliance or operate it.
You touched 2 or more sensor fields at the same
time. Only touch one sensor field.
There is water or fat stains on the control panel.
Clean the control panel.
Start the appliance again and set the heat setting
in 10 seconds.
The child safety device or key lock or Stop+Go
operates. See the chapter Operating the appli-
ance.
A sound operates when
the appliance is off.
You covered one or more sensor fields. Uncover the
sensor fields.
The residual heat indica-
tor does not come on.
The cooking zone is not hot because it operated
only for a short time. If the cooking zone is sup-
posed to be hot, speak to the After Sales Service.
Heat setting alternates The Power management is active. See the section
Power management.
A sound operates and
appliance starts and
stops again. After 5 sec-
onds one more sound
operates.
You covered . Uncover the sensor field.
comes on
The automatic switch-off operates. Stop the ap-
pliance and start it again.
Overheating protection for the cooking zone op-
erates. Switch off the cooking zone. Switch on the
cooking zone again.
14
www.aeg.com
Vista de página 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Comentários a estes Manuais

Sem comentários