Aeg-Electrolux E8831-7-M Manual do Utilizador descarregar pdf (Página 31)

2. Pull the door trim to the front to remove

it.

3. Hold the door glass panels on their top edge one by one and pull them upwards out

of the guide

4. Clean the door glass panels.

To install panels follow the procedure in reverse. Insert the smaller panel first, then

the larger.

WHAT TO DO IF…

WARNING!

Refer to "Safety information" chapter.

Problem Possible cause Solution

The cooking zones do not op-

erate

Consult the operating instructions for the built-in cooking sur-

face

The oven does not heat up The appliance is switched off Switch on the appliance

The oven does not heat up The clock is not set Set the clock. Refer to "Setting

the clock"

The oven does not heat up The necessary settings are not

set

Make sure, the settings are cor-

rect

The oven does not heat up The automatic cut-out is

switched on

Refer to „Automatic cut-out“

The oven does not heat up The fuse is released Make sure, if the fuse is the

cause for the malfunction. If

the fuse releases again and

again, refer to an authorized

electrician

The oven lamp does not operate The oven lamp is defective Replace the oven lamp.

The display shows F11 • There is a short circuit of

the meat probe

• The meat probe plug is not

correctly installed into the

meat probe socket

Install the meat probe plug as

far as possible

What to do if…

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Sem comentários

Aeg-Electrolux E8831-7-M Manual do Utilizador Página 31